Saratov, Saratov, Russian Federation
Himki, Moskovskoy oblasti, Moscow, Russian Federation
The ways to increase grinding effectiveness by means of physical –chemical process control in a “disk-billet” contact are considered. The impact of physical-chemical properties of cutting emulsion (CE) upon grinding basic indices is shown. The hierarchical threshold structure of a grinding process based on a neuronet model allowing automating the machining techniques designing is offered.
grinding, cutting emulsion, cutting power, wear.
1. Bezyazychny V.F. Influence of surface layer quality after machining upon machinery performance attributes // Surface Engineering: Supplement to Journal: Reference Book. Engineering Journal. 2001. № 1. pp. 9 – 17.
2. Suslov A.G. Parameter State Technological Support for Part Surface Layer. М.: Mechanical Engineering, 1987.
3. Yankin I.N., Brzhezovsky B.M., Brovko M.B. Grinding quality assurance based on dynamic interaction peculiarities of tool and produce subsystems / // Proceedings of the 7-th Inter. Scientific –tech. Conf. ”DTS-2004”. Saratov, 2004. pp. 372 – 375.
4. Brzhezovsky B.M., Slavin А.V. Cutting emulsion influence upon chip forming at metal grinding // Bulletin of State Technical University of Saratov. 2011. № 4 (60). Issue 2. pp. 138 – 142.
5. Slavin А.V., Shumyacher V.М. Mechanical – chemical processes of abrasive tool and billet at metal grinding //Engineering Techniques. 2008. № 1. pp. 29 – 32.
6. Filimonov L.N. High-speed Grinding. L.: Mechanical Engineering, 1979. pp. 248.
7. Slavin А.V. Threshold hierarchical system as means for factor analysis of abrasion processes // Bulletin of the State Technical University of Saratov. 2013. № 1 (69). pp. 116 – 118.