CORRELATION INVESTIGATION OF SURFACE ROUGHNESS IN PROTOTYPED SAMPLES WITH CONDITIONS OF THEIR LOCATION AT MANUFACTURING
Rubrics: MECHANICAL ENGINEERING AND TRANSPORT
Authors:
1.
Institute of Design Technological Informatics of RAS
( Junior research assistant)
employee
Moscow, Moscow, Russian Federation
employee
Moscow, Moscow, Russian Federation
2.
Institute of Design and Engineering Informatics of the Russian Academy of Sciences
( Leading Researcher)
Russian University of Transport (Department of Technology of Transport Engineering and Repair of Rolling Stock, Professor)
employee
Moscow, Moscow, Russian Federation
Russian University of Transport (Department of Technology of Transport Engineering and Repair of Rolling Stock, Professor)
employee
Moscow, Moscow, Russian Federation
3.
Russian University of Transport
( Senior Lecturer)
employee
Moscow, Moscow, Russian Federation
employee
Moscow, Moscow, Russian Federation
Type:
Article
Pages:
from 108
to 111
Status:
Published
Received:
23.06.2016
Accepted:
15.01.2023
Published:
30.06.2016
Language:
Russian
Keywords:
prototyping, machinery, photopolymer, layered printing, roughness, location conditions
Abstract (English):
The purpose of this work is to reveal the influence of the location of the product grown upon roughness during shaping at prototyping. To achieve the goal specified there were chosen plates with dimensions 10x10x3mm, and the surface investigated – a plane 10x10mm. Some sets of plates were printed on a 3D printer Envision Ultra 2 of high-temperature photo –polymeric resin NTM 140 according to Direct Light Projection (DLP). The plates made of NTM 140 after extraction from a printer have temperature durability of 140°C. For more exact and deep researches of the phenomenon mentioned there was used a method of atomic – power microscopy (APM) for the definition of the surface micro-relief in samples under investigations. As a basic tool for the analysis of surface micro-relief a scanning microprobe microscope Solver Pro, and program package WSxM allowed obtaining 3D images of a surface layer of samples. It is evident from the results presented that at the formation of a flat by means of the quick prototyping method according to a DLP type technology the most optimum scheme of location is that at which the angle of basic plane slope makes 8°.
The purpose of this work is to reveal the influence of the location of the product grown upon roughness during shaping at prototyping. To achieve the goal specified there were chosen plates with dimensions 10x10x3mm, and the surface investigated – a plane 10x10mm. Some sets of plates were printed on a 3D printer Envision Ultra 2 of high-temperature photo –polymeric resin NTM 140 according to Direct Light Projection (DLP). The plates made of NTM 140 after extraction from a printer have temperature durability of 140°C. For more exact and deep researches of the phenomenon mentioned there was used a method of atomic – power microscopy (APM) for the definition of the surface micro-relief in samples under investigations. As a basic tool for the analysis of surface micro-relief a scanning microprobe microscope Solver Pro, and program package WSxM allowed obtaining 3D images of a surface layer of samples. It is evident from the results presented that at the formation of a flat by means of the quick prototyping method according to a DLP type technology the most optimum scheme of location is that at which the angle of basic plane slope makes 8°.
Keywords:
prototyping, machinery, photopolymer, layered printing, roughness, location conditions
prototyping, machinery, photopolymer, layered printing, roughness, location conditions
1. Grabchenko, А. I. Integrated generative Techniques: Manual / А. I. Grabchenko, Yu. N. Vnukov, V.L. Dobroskok;Ed. А.I. Grabchenko. – Kharkov: NTU “KhPI”, 2011. – pp. 416.
2. http://www.cybercom.ru.
