Accuracy increase in cog-wheel finishing

V. Klepikov; Aleksandr Cherepakhin

doi:doi:10.12737/20596

Accuracy increase in cog-wheel finishing

Published в Science intensive technologies in mechanical engineering · Volume 1, Issue 7, 2016 · Pages 24–27 · Rubrics: SCIENCE INTENSIVE TECHNOLOGIES OF MACHINING (archived)

DOI 10.12737/20596

Received: 04.07.2016 Accepted: 04.07.2016 Published: 04.07.2016 Language of publication: RUS

Authors

V. Klepikov · Aleksandr Cherepakhin

ABSTRACT

One of the most problem areas in the technological process of cog-wheel machining is a succession of roughing (by a hob) and finishing (by shaving). In the paper there are shown the results of comparative experimental researches of a succession heredity “milling by a hob –shaving) at working with an uncorrelated and correlated shaver. The shaver correction was carried out according to the results of the analysis of toothing and accuracy parameters (profile error) of a milling wheel.

KEYWORDS

hob shaver cog-wheel machining accuracy profile correction.

Information Text References

Authors:

Type:

Article

Pages:

from 24 to 27

Status:

Published

Language:

Russian, English

Keywords:

hob, shaver, cog-wheel, machining accuracy, profile correction.

Text

Text (PDF): Read Download

References

1. Modern Methods of Cog-wheel Machining / А.S. Ka-lashnikov, Yu.А. Morgunov, P.А. Kalashnikov. М.: Publishing Center “Spectrum”, - 2012. - pp. 239.

2. Klepikov V.V., Taratynov О.V., Kurochkin N.А., Solonitsyn B.М. Analysis of quality formation in involute surfaces of spur gears // Bulletin of Mechanical Engineering. - 2005. - № 3. - pp. 49-53.

3. Cherepakhin А.А, Klepikov V.V., Soldatov V.V. Me-thods of Critical Parts Working for Motor Cars. М.: MSIU, 2011. - pp. 214.

4. Parametric Optimization of Cog-Wheel Machining. Monograph: Cherepakhin А.А., Vinogradov V.М., Klepikov V.V./ Deutschland, Saarbrucken, the publishing house LAP Lambert Academic Publishing GmbH &Co., 2012 г. - 230

5. Taratynov О.V, Klepikov V.V., Cherepakhin А.А. Ways for technological system up-dating // Engineering Techniques. - 2014. - № 9. - pp. 61-63.

6. Klepikov V.V., Cherepakhina А.А. Ways for technological process up-dating in parts finishing // Science Intensive Techniques in Mechanical Engineering. - 2014. - № 12(42). - pp. 15- 18.

Accuracy increase in cog-wheel finishing

Confirmation

Регистрация