employee
employee
The proposed method of calculation made with the setpoint wane proved its effectiveness was tested and showed the following results. Volumetric output of lumbers with a blunt wane obtained by the method of cutting breakup increase compared with edging materials obtained in the same way cutting, by 7 %, that is 1.13 times. Volumetric output edged lumbers blunt wane when cutting with squaring increase by 14.17 %, that is 1.27 times. Volumetric output edged lumbers blunt wane obtained lumber-breakup means cutting increases in comparison with breakup method of cutting to 7.17 %, that is 1.085 times.
timber, raw, sawn, lumber, wane.
1. Aksenov, P. P. Teoreticheskie osnovy raskroya pilovochnogo syr´ya [Tekst] / P. P. Aksenov. – M.-L. : Goslesbumizdat, 1960. – 216 s.
2. Krylov, G. V. Metody eksperimental´noy optimizatsii v derevoobrabotke [Tekst] : ucheb. posobie / V. G. Krylov, V. E. Pyatkov. – M., 2013. – 34 s.
3. Rykunin, S. N. Planirovanie raskroya pilovochnogo syr´ya i raschet proizvoditel´nosti potochnykh liniy [Tekst] : ucheb. posobie / S. N. Rykunin, V. E. Pyatkov. – M., 2011. – 80 s.
4. Kondratyuk, D. V. Tekhnologicheskie resheniya pererabotki listvennykh korotkomernykh sortimentov [Tekst] / D. V. Kondratyuk, E. V. Kravtsov. Vestnik Moskovskogo gosudarstvennogo universiteta lesa – Lesnoy vestnik. – M., 2012. – № 8 (91). – S. 38–41.
5. Fergin, V. R. Aktual´nye voprosy teorii raskroya pilovochnogo syr´ya [Tekst] : ucheb. posobie / V. R. Fergin, O. I. Shako, O. I. Erkhova. – M., 2010. – 95 s.
6. Kulikova, N. V. Proektirovanie izdeliy i tekhnologicheskikh protsessov derevoobrabatyvayushchikh proizvodstv. Printsipy proektirovaniya derevyannykh domov v programme KZ-Kottedzh [Tekst] : ucheb. posobie. – M., 2009. – 202 s.
7. Rykunin, S. N. Metody sostavleniya i rascheta postavov [Tekst] : ucheb. posobie / S. N. Rykunin, V. E. Pyatkov. – 3-e izd., – M., 2008. – 76 s.
8. Lundahl C. G. Optimized processes in sawmills. Licentiate thesis. Lulea˚ University of Technology, Division of Wood Technology, Skelleftea, Sweden. – 2007.
9. Anders Lycken doctoral thesis Appearance Grading of Sawn Timber LTU Skellefteå Luleå University of Technology Skeria 3, S-931 87 Skellefteå, Sweden http://www.ltu.se/ske 2006
10. Jaakko Vuorilehto Measuring technology at mechanical wood processes Lappeenranta university of technology mechanical engineering department of wood technology.
