Russian University of Transport (Department of Technology of Transport Engineering and Repair of Rolling Stock, Professor)
employee
Moscow, Moscow, Russian Federation
graduate student
Moskva, Moscow, Russian Federation
The process of threadcutting process in holes with ultrasmall diameters is considered. It is revealed that because of the peculiarities arisen the thread-cutting conditions become tougher and bending loads in a tap operating arise.
thread-cutting, ultra-small diameter, fine turning, cuttings section
1. Kulikov, М.Yu. Reliability investigation of thread-cutting process in holes with ultra-small diameters / М.Yu. Kulikov, М.V. Yagodkin // Proceedings of KSU. – 2015. – №5. – pp. 61-62.
2. Rykunov, А.N. Peculiarities of wearresistant tool coatings at fine turning / А.N. Rykunov // Reference Book. Engineering Journal. – 2000. – №4. – pp. 10-11.
3. Rykunov, А.N. Fine Turning. Simulator, Mode Limits, Physical Peculiarities and Process Technological Potentialities / А.N. Rykunov. – Rybinsk: RSATA, 2003. – pp. 258.
4. Rukunov, А.N. Thermalphysic analysis of edge cutting machining with small thick shears / А.N. Rykunov //Bulletin of VVO ATN RF. – 2010. - №1. – pp. 128-134.
