Manufacturability factor analysis of product design fulfillment

Boris Bazrov; Alexandr Troitsky

doi:doi:10.30987/article_5b313524d7d135.99409616

UDC 62

Manufacturability factor analysis of product design fulfillment

Published в Science intensive technologies in mechanical engineering · Volume 2018, Issue 7, 2018 · Pages 23–26 · Rubrics: FUNCTION-ORIENTED AND MODULAR TECHNOLOGIES (archived)

DOI 10.30987/article_5b313524d7d135.99409616

Received: 25.06.2018 Accepted: 14.07.2018 Published: 14.07.2018 Language of publication: RUS

Authors

Boris Bazrov ¹ iD · Alexandr Troitsky ²

1 Institute of Mashine Science named after Blagonravov RAS (Chief researcher)
Moskva, Russian Federation

2 FGBUN IMASh RAN im. Blagonravova (Post graduate student)
Moskva, Moscow, Russian Federation

ABSTRACT

In the paper there is presented a type and characteristic classification of parts based on the variety of product design fulfillment. The analysis of manufacturability coefficients is carried out to which belong coefficients of standardization, unification, repeatability and typification. Their tie with the labour-intensiveness of design-technological pre-production and labour-intensiveness of part machining is defined. There are shown drawbacks of the coefficients considered, for instances, in coefficients of standardization and unification one does not take into account different degrees of influence upon labour-intensiveness of constituents of these coefficients, besides, a repeated account of standard parts takes place. In the coefficients of typification and repeatability both variety of parts and their number in one group of items or one standard representative are not taken into account.

KEYWORDS

part manufacturability factors standardization unification repeatability typification

Information References

Authors:

1. Institute of Mashine Science named after Blagonravov RAS (Chief researcher)

Moskva, Russian Federation

2. FGBUN IMASh RAN im. Blagonravova (Post graduate student)

Moskva, Moscow, Russian Federation

Type:

Article

Pages:

from 23 to 26

Status:

Published

Subject area:

UDC 62

Language:

Russian, English

Keywords:

part, manufacturability, factors, standardization, unification, repeatability, typification

References

1. RSS 14.205-83 “Manufacturability of Product Design”.

2. Procedure of Design Updating for Manufacturability and Assessment of Manufacturability Level of Parts of Me-chanical Engineering. - M.: Publishing House of Standards, 1976. - pp. 56.

3. Amirov, Yu.D., Alfyorova, T.K., Volkov, P.N. Manu-facturability of Product Design: reference book. - M.: Me-chanical Engineering, 1985. - pp. 368.

4. Bazrov, B.M., Troitsky, A.A. Analysis of method for assessment of product design manufacturability as subject of manufacturing // Reference Book. Engineering Journal with Application. - 2017. - No.4 (241). - pp. 39-43.

Manufacturability factor analysis of product design fulfillment

Confirmation

Регистрация