APPLICATION OF HOLE AXIS ALIGNMENT AT DRILLING PIPES OF DIFFERENT PURPOSE
Authors:
1.
Perm National Research Polytechnic University
(kafedra "Innovacionnye tehnologii mashinostroeniya", Post graduate student)
Perm, Perm, Russian Federation
Perm, Perm, Russian Federation
Type:
Article
Pages:
from 38
to 42
Status:
Published
Received:
28.03.2021
Accepted:
07.01.2023
Published:
03.02.2022
Subject area:
UDK 62 Инженерное дело. Техника в целом. Транспорт
Language:
Russian
Keywords:
deep hole machining, hole axis moving away, hole axis deviation, axis correction
Abstract (English):
A plant ensuring control of cutter parameters during deep drilling pipes of a different purpose to increase effectiveness of deep hole machining in parts of “pipe” type is considered. The plant allows controlling the following parameters: tool rotation, feed, parts rotation, runout on the outer surface of a part and its wall thickness.
A plant ensuring control of cutter parameters during deep drilling pipes of a different purpose to increase effectiveness of deep hole machining in parts of “pipe” type is considered. The plant allows controlling the following parameters: tool rotation, feed, parts rotation, runout on the outer surface of a part and its wall thickness.
Keywords:
deep hole machining, hole axis moving away, hole axis deviation, axis correction
deep hole machining, hole axis moving away, hole axis deviation, axis correction
1. Utkin, N.F., Kizhnyaev, Yu.I., Pluzhnikov, S.K. Deep Hole Machining. – L.: Mechanical Engineering, 1988. – pp. 269.
2. Gorelova, A.Yu., Pleshakov, A.A., Kristal, M.T. Me-thods for accuracy increase in deep hole machining // Proceed-ings of Tula State University. Engineering Sciences. – Issue 7. – Part 2. – 2013. – pp. 363-370.
