GRNTI 55.13 Технология машиностроения
The article presents the results of research on the dynamics of the process of turning parts of rocket technology made of titanium alloy VT-6. The effect of the feed value on the cutting force and chip shrinkage during turning of the VT6 titanium alloy was determined experimentally.
cutting of titanium alloys, cutting force, chip shrinkage coefficient, experimental studies
1. Koryagin S.I., Pimenov I.V., Hudyakov V.K. Sposoby obrabotki materialov: Uchebnoe posobie / Kaliningr. un-t – Kaliningrad, 2000. – 448 s.
2. Zhuchkov N.S., Bespahotnyy P.D., Chubarov A.D. i dr., Povyshenie effektivnosti obrabotki rezaniem zagotovok iz titanovyh splavov. M., «Mashinostroenie», 1989. – 152 s.
3. Obrabotka rezaniem staley, zharoprochnyh i titanovyh splavov s uchetom ih fiziko-mehanicheskih svoystv M.: TEHNOSFERA, 2018. - 508 s.
4. Kugul'tinov S. D., Koval'chuk A. K., Portnov I. I. Tehnologiya obrabotki konstrukcionnyh materialov. - M., Izd-vo MGTU im N. E. Baumana, 2006. – 671 s.
5. Kugul'tinov S.D., Koval'chuk A.K., Portnov I.I. Obrabotka rezaniem materialov, primenyaemyh v raketostroenii. – M.: MGTU im. N.E. Baumana, 2008. – 194 s.
6. NPAOP 27.4-1.42-62 Pravila bezopasnosti pri vyplavke i obrabotke titana i ego splavov (utverzhdeny Prezidiumom CK, profsoyuza aviacionnoy i oboronnoy promyshlennosti 30 iyulya 1962 goda)
