Volgograd State Technical University (Kafedra «Tehnologiya mashinostroeniya i prikladnaya mehanika», prof.)
Saratov, Saratov, Russian Federation
Saratov, Saratov, Russian Federation
A present state of approaches and procedures for the assessment of product manufacturability is considered. There are shown sources of information and regulatory-reference literature on types, indices and methods of part design optimization for manufacturability. Current directions in scientific investigations in the field of manufacturability assurance of a product design are presented.
product design manufacturability, product design optimization for manufacturability, methods for assessment of product design manufacturability, product manufacturability
1. RSS 14.205-83. Product Design Manufacturability. Terms and Definitions: Official Edition. Instead of RSS 18831-73. – M.: Standards Publishers, 1983.
2. RSS 14.201-83*. Assurance of Product Design Manu-facturability. General Requirements: Official Edition instead of RSS 14.201-73. – M.: Standards Publishers, 1983, - pp. 9.
3. Product Design Manufacturability: reference book / un-der the general editorship of Yu.D. Amirov. – 2-d edition revised and supplemented. – M.: Mechanical Engineering, 1990. – pp. 768.
4. MR 186-85. Product Design Manufacturability Assur-ance of Engineering and Instrument Making. Methodical Rec-ommendations: Official Edition. – M.: AURIMach, 1985. – pp. 52.
5. Yanovsky, G.A. Procedure of Design Optimization for Manufacturability and Manufacturability Assessment of Engi-neering Products and Products of Instrument Making – M.: AURIMach, 1973. – pp. 102.
6. Genkin, S.I. Methods for Assessment of Engineering Product Manufacturability. – M.: AURIMach, 1974. – pp. 173.
7. Bochkaryov, P.Yu. Assessment of Manufacturability: manual / P.Yu. Bochkaryov, L.G. Bokova. – S-Pb.: “Lan” Publishers, 2017. – pp. 132.
8. Solomentsev, Yu.M. Information-Computer Systems in Mechanical Engineering CALS-Technologies / Yu.M. Solo-mentsev, V.G. Mitrofanov, V.V. Pavlov [et al.]. – M.: Science, 2003. – pp. 292.
9. Safonov, S.V. Technological Support of Product Opera-tion Characteristics. – Voronezh: IPC VSU, 2015. – pp. 225.
10. Bazrov, B.M. Problem in support of product manufac-turability // Science Intensive Technologies in Mechanical En-gineering. – 2016. – No.4 (58). – pp. 30-34.
11. Bazrov, B.M. Manufacturability of product design and its assessment // Bulletin of Mechanical Engineering. – 2018. – No.6. – pp. 47-50.
